Canal Station Condominium
  • Welcome Home!
  • CS NewsFeed
  • Who do I call for...?
  • Rules & Violations
  • Owners' Towing Info
  • Owners' Calendar & Documents
  • Board & Committees
  • Board Member Resources
  • Amenities & Reservations
  • Maint. Requests/Incident Reports
  • Update your Info!
  • Rentals by Owner
  • Commercial Spaces
  • DIY Maintenance Tips
  • Recycling Info
  • Ballard Food Bank

Unit Safe Operating Instructions

6/3/2019

0 Comments

 
Canal Station Wall Safe Operating Instructions
 
CAUTION: Do not keep the keys IN the safe!
 
1. OPENING THE SAFE

 
To open the door of the safe for the first time: Press 1, 5, 9 (this is the preset numbers when the safe leaves the factory) and confirm by pressing the letter “A”. You will hear a beep and the green light will be on, and then open the door using the knob within 5 seconds.
 
If you or an intruder uses the incorrect group of numbers, it will not open. If you incorrect combination is used 3 times consecutively, you must wait for 20 seconds before reattempting.
 
If again the incorrect combination is selected 3 times, you must wait approximately 5 minutes before reattempting.
 

2. PROGRAMMING THE CODE


Press the red button on the back of the door near the hinge, release it and you will hear two beeps.
 
Now press from 3 to 8 numbers that you wish to use as a combination, and confirm by pressing the letter “B” within 15 seconds. Or you have to repeat from the beginning.
 
Write down your new combination immediately and check whether your new combination has been programmed or not on the condition of the safe door open.
 

3. BATTERY REPLACEMENT WARNING

 
If the batteries are low, the red light will warn you immediately. To test the batteries, just input your personal numbers to open the door. If the batteries are low, the red light will be on. If nothing happens, it means that the batteries are in order.
 

4. REPLACING THE BATTERIES

 
The safe requires 4x”AA” size (1.5V R06) batteries.
 
Open the safe, push the battery cover plate on the back of the door and replace the 4 PCS old batteries. You must reprogram the code using the above steps.
 
Use of alkaline batteries is recommended.
 

5. OVERRIDE INSTRUCTION TO OPEN THE SAFE

 
For your convenience, we have engineered a manual override system for your safe. If you forget or misplace your combination, remove the small PVC showing the key on the front panel, insert the key into the keyhole and turn it in a counter-clockwise direction, then turn the knob in a clockwise direction towards the right. This will manually open your safe at any time.
 

 
CAUTION: The safe should be placed horizontally when installing the safe.
0 Comments

Your comment will be posted after it is approved.


Leave a Reply.

    RSS Feed

    Categories

    All
    Board Info
    Events
    Luxer Parcel Room Info
    Maintenance Tips
    News From The Elevator
    Notices
    Pandemic Info
    Rule Changes
    Safety Awareness
    Wildlife

  • Welcome Home!
  • CS NewsFeed
  • Who do I call for...?
  • Rules & Violations
  • Owners' Towing Info
  • Owners' Calendar & Documents
  • Board & Committees
  • Board Member Resources
  • Amenities & Reservations
  • Maint. Requests/Incident Reports
  • Update your Info!
  • Rentals by Owner
  • Commercial Spaces
  • DIY Maintenance Tips
  • Recycling Info
  • Ballard Food Bank